I didn't mean it. Why did they not pass the red light?

From January 1st, 2013, the violation of the road traffic lights will be increased from 3 points to 6 points. The "red light stop, green light line" traffic regulations are further valued by drivers. In some cases, we accidentally missed the red light and we are helpless. We really do not want to have a red light. Of course, there are many kinds of situations in which red lights are divided. If the stop line is crossed after the red light is on, it is not necessarily a red light. Let's take a look at how we deal with these situations.

I didn't mean it. Why did they not pass the red light?

● Don't be afraid of these conditions when crossing the stop line

The front exits the stop line

Many drivers will hesitate to speed through the intersection when the yellow light flashes. I do not know when the red light will be on. At this time, one foot brake slams and there is just a part of the body over the stop line. Moving again, this situation is not counted as a red light and will not be fined.

I didn't mean it. Why did they not pass the red light?

The electronic eye will take three pictures as evidence of a red light as the vehicle passes the stop line, reaches the middle of the intersection, and arrives at the opposite intersection. At this point, as long as the green light is on again, you can pass through the intersection.

Crossing traffic police to direct traffic

I didn't mean it. Why did they not pass the red light?

The driver must have encountered traffic lights and traffic police at crossings. Even if it is a red light, the traffic police may also indicate the driver’s access according to the situation at that time. At this time, we must use the traffic police's gesture as the standard. All should follow the command of the traffic police. There is no fear of the police aunt.

After obeying the command of the traffic police, they were recorded with a red light behavior. They could apply to the traffic police brigade to issue a reassignment certificate and be free from punishment.

Red light is captured for reconsideration

I didn't mean it. Why did they not pass the red light?

After capturing the red light, there is a process of information verification. It will not only capture the situation of the vehicle, but also the signal light and surrounding conditions. For some violations of traffic lights due to special reasons, it can be verified and corrected according to law enforcement procedures. It is not because of the red light caused by the driver's own fault. It can be solved through administrative reconsideration, administrative litigation and other channels.

I didn't mean it. Why did they not pass the red light?

For example, if a driver urgently transports a patient with a red light, or avoids a special vehicle (ambulance, fire engine, armed police force, etc.), it will generally not be punished if he passes the stop line. Not only will not be punished, we also encourage this behavior.

● Punishment of red lights is just like a minute

Red line over the body of the parking line

We have also seen some drivers brake less than enough, causing all the vehicles to pass the stop line. At this time, even if they stopped at the intersection, they did not dare to move, affecting the normal traffic on both sides of the vehicle.

I didn't mean it. Why did they not pass the red light?

This situation belongs to cross-line parking and is not considered a red light. According to the "Score Score for Illegal Conduct in Road Traffic Safety", two points will be deducted at a time if the traffic crossing does not follow the rules or the vehicle is parked. Punishment is not as severe as the red light, but it also costs 2 points.

If the vehicle is parked across the line, it feels like the location of the car is very embarrassing. When it is improperly parked in the center to try to reverse the penalty to avoid punishment, it will also have to pay the price of fines. According to regulations, motor vehicles may not be reversed at railway crossings, intersections, single-lane roads, bridges, sharp bends, steep slopes or tunnels. If you reverse the car, you may be fined between 20 yuan and 200 yuan.

Follow the car too close to the line of sight

Sometimes the size of the vehicle in front of the vehicle is too large to block the line of sight. The rear vehicle follows the front car and crosses the intersection. The result is a red light.

I didn't mean it. Why did they not pass the red light?

The rear driver must feel embarrassed, not wanting to go to the red light but actually not seeing. However, in this case, if the rear-driver can maintain a sufficient range of observations, it should be able to see the signal lights in front and ensure the safe braking distance as the standard. In this case, the rear vehicle should also be punished according to the red light.

The yellow light passes through the junction

Previously, the driver's definition of the yellow light was rather vague. When the yellow light was on, they all loved to speed up and grab the intersection. They did not want to wait for the next green light. It is in order to save this short period of time that rushing yellow lights can easily cause traffic accidents.

I didn't mean it. Why did they not pass the red light?

According to the “Regulations of the People’s Republic of China on Road Traffic Safety Law,” the yellow light at the intersection is flashing, and vehicles that have crossed the stop line can continue to drive. If the yellow light has been on, it will continue to be forced to pass, so that if it is photographed, it will be punished according to the red light.

● Postscript

At the beginning, when we did not obtain a driver's license, we all knew about the traffic lights. Often after obtaining a driver's license, fortunate enough to make the driver pay a penalty penalty. Strictly observing the instructions of the signal lights is what every driver should do. He should also know for himself whether he is running a red light.

Bolt Bonnet Gate Valve with ASME, DIN, GOST or EN standard is the best popular type shut off valve in any kind of low pressure industrial pipelines, Class 150(PN16) to Class600(PN100) matching valve size from 2"(DN50) to 40[(DN1000), which can be operated by electric actuator or handwheel. Bolt bonnet Gate Valve normally with flange ends connection with industrial pipeline as well as welding ends. Valve material can be carbon steel, stainless steel, alloy steel or special steel according the requirements of the working medium. 

Bolt Bonnet Gate Valve

Bolt Bonnet Gate Valve,Manual Gate Valve,Stainless Steel Gate Valve,Motor Gate Valve

Yongjia South Trading Co.,Ltd , https://www.n-lvalve.com